ELCAST Lighting
ELCAST Lighting
Products About us Custom services Contact us
Square Non-Tapered Poles

return printable version
get PDF version
    // Architectural Lighting // Pole Mount // Square Non-Tapered Poles
    POLE SHAFT
The pole shall be a one section design fabricated from standard 11 gauge (0.1196") or 7 gauge (0.1793") steel. Each section sahll be fabricated from high strength low alloy steel conforming to ASTM A500 Grade B, with a minimum yield strength of 46,000 psi. Each pole will have a full-length longitudinal weld and will be square in cross-section.

BASE PLATE
The base plate is fabricated from a strutural quality hot rolled carbon steel plate that meets or exceed ASTM A-36 with a minimum yield of strength of 36,000 psi. The base plate telescopes the poles hsaft and is circumferential welded top and bottom. The base plate has slotted bolt holes.

HAND HOLE
A reinforced hand hole, having a nominal 3" x 5" opening, will be installed 18" above the base plate on all poles. A hand hole cover and attaching hardware is included with each hand hole assembly. A ground lug will be welded either on the hand hole frame or on the inside of the pole opposite the hand hole depending on the design.

ANCHOR BOLTS
Anchor bolts are fabricated from a commercial quality hot rolled carbon steel bar that meets or exceeds minimum yield strength of 55,000 psi. Anchor bolts are sized according to each pole design and are furnished with 2 galvanized heavy hex nuts and 2 galvanized flat washers. Anchor bolts shall be galvanized a minimum of 4" on the threaded end in accordance with ASTM A-153. Anchor bolts will ship with the poles unless otherwise specified.
return printable version
get PDF version


 

Home | About us | Products | Custom services | Contact us

2004-2006 Elcast Lighting. All rights reserved.