ELCAST Lighting
ELCAST Lighting
Products About us Custom services Contact us
Square Tapered Poles

return printable version
get PDF version
    // New Products // Pole Mount // Square Tapered Poles
   

POLE SHAFT
The pole shall be a one section design fabricated from standard 11 gauge (0.1196") or 7 gauge (0.1793") steel. Each section shall be fabricated from high strength low alloy steel with minimum yield strength of 50,000 psi. Each pole will have a full length longitudinal weld and will be square in cross-section with a uniform taper of 0.11 inches per foot of length.

BASE PLATE
The base plate is fabricated from a structural qulity hot rolled carbon steel plate that meets or exceeds ASTM A-36 with a minimum yield of strength of 36,000 psi. The base plate telescopes the pole shaft and is circumferential welded top and bottom. The base plate has round bolt holes.

HAND HOLE
A reinforced hand hole, have a nominal 3" x 5" opening will be installed 18" above the base plate on all poles. A hand hole cover and attaching hardware is included with each hand hole assembly. A ground lug will be welded either on the hand hole frame or on the inside of the pole opposite the hand hole depending on the design.

ANCHOR BOLTS
Anchor botls are fabricated from commercial quality hot rolled carbon steel bar that meets or exceeds minimum yield strength of 55,000 psi. Anchor bolts are sized according to each pole design are are furnished with 2 galvanized heavy hex nuts and 2 galvanized flat washers. Anchor bolts shall be galvanized a mimimum of 4" on the threaded end in accordance with ASTM A-153. Anchor bolts will ship with the poles unless otherwise specified.

return printable version
get PDF version


 

Home | About us | Products | Custom services | Contact us

2004-2006 Elcast Lighting. All rights reserved.